Lines cannot be thinner than 0.1

Hello. I’ve been using Linearity Curve since November of 2022 and I’ve always had the ability to make pen tool lines thinner than 0.1 by using the slider manually on the quick menu that pops up every time you tap on an object (I’m on iOS). I’m not sure if this was intentional, but I’ve not been able to make lines thinner than 0.1 since the last update. I use extremely thin lines quite often, as I design racetrack with many small markings on roads, and only being able to do 0.1 lines now makes it very difficult and annoying. Please fix this and revert it to how it was because at the moment I’m pretty displeased about an otherwise good program.


Above and below are what I used to be able to do.

Below is the only thing that can be done now.

Even in the larger menu, nothing can be done. I’m able to type the value less than 0.1 in, sure. However, when I click off and/or hit enter, it just sets itself back to 0.1. This essentially means that I can never make a new shape that has a width thinner than 0.1 without copying and adjusting a shape that existed prior to the update.